>Using: MS VPC-2007-SP1
>
>I'm having problems disregarding changes when I use VPC. I made some changes
>with an XpPro-SP3 virtual machine, and then closed the VM. I was expecting
>the changes to be ignored/disregarded, but when I restarted the VM, the
>changes were still there.
>
>IIRC, at one point there were multiple options when you clicked on the upper
>right X to close the VM, including:
>* Save state
>* Close and save state
>* Close and ignore changes
>(don't remember exact wording, might have been a 4th)
>
>I updated computers and re-install VPC-07-SP1, and am no longer seeing the
>options above, but only the basic:
>
>* Save state
>* Turn off
>
>Am I doing something wrong, or have a setting wrong?
>
>I want to be able to start a VM, try something out, and then close the VM
>and have all changes ignored / disregarded / thrown away.
>
>What I'm doing now is saving a "master" of the "vanilla" VM of XpPro-SP3,
>and copying it back as a way to "put everything back the way it was".
>
>

> >Am I doing something wrong, or have a setting wrong?
>
> You need to enable "Undo Disks" for that VM. It's in the VM's
> settings and the VM has to be in a fully shut down state to change it.
>
> --
> Bob Comer

>Thanks ... that was what I was missing.
>
>
>"Robert Comer" <(email address - cut out)> wrote in message
>news:(email address - cut out)...
>> >Am I doing something wrong, or have a setting wrong?
>>
>> You need to enable "Undo Disks" for that VM. It's in the VM's
>> settings and the VM has to be in a fully shut down state to change it.
>>
>> --
>> Bob Comer
>